Supernova...take two

I have been pretty busy lately, between commissions and some sculpting, that I just haven't managed to get photos up here! This week was so rainy that I couldn't really paint--the paint just wouldn't dry and I was getting frustrated, plus with the blowing wind I couldn't spray outside. So, I sculpted! Last week I finished and sent off a bunch of micro minis, this week I started working on a traditional who you've seen before if you read this blog (or maybe at Breyerfest).

Supernova, in his non-hardening clay form, had gotten to the adding details point. He is/was very near the point where I need to make a mold and cast him so that I can continue refining him and finish him up. However, when I moved I had to throw out my resin because the bucket broke and one part spilled, so making a mold would require ordering more resin (and probably more rubber as well). Then once the mold is made, it's a tedious process cleaning up the resin casting just to get it back to where I was before making the mold. This is why I pay someone else to do my molds and castings for the production runs--I am perfectly capable of making a mold that will work, but without equipment like a spin-caster it's difficult to get good castings.

Since I was reluctant to make a mold, I decided to do the next best thing. I resculpted Supernova from scratch in Apoxie Sculpt.

This hasn't been as difficult as you might think--since I already have the plasticine version here, I can take measurements off of that and use it as a model. This helps to eliminate some of the major problems with working directly in epoxy, and I am hoping that I will be able to keep the cutting or grinding off and resculpting of major body parts to a minimum. So far I've pretty much just got Apoxie globbed on; there will be much sanding and building back up yet to do. It's still time consuming, but I'm not sure that it's any more time consuming than making a mold and it does cost much less in materials!